Allmand Maxi-Power MP65 T4F, Operator'S Manual

Page: 26 / 76

Not for
Reproduction
26 ALLMAND.COM
Operation
34
Check Fuel
Before starting operation, make sure to check the level of residual fuel so that fuel shortage during
operation can be avoided. If necessary, drain condensate accumulated at the bottom of the fuel tank.

Refilling fuel tank should be done in an outdoor well-ventilated place.

Do not fill fuel up to the filler level.
When fuel tank is filled up to the filler level, the expansion volume of the tank is too small and could lead
to problems with fuel flow and containment. Furthermore, fuel may spill from the fuel tank due to vibration
caused during movement or transportation of the unit.
※
When using an external fuel tank, note that the Fuel Level indication on the monitor will not reflect the
actual fuel level.
D004

Do not, under any circumstance, bring lit cigarettes and/or
matches to the fuel.

The fuel is extremely flammable and dangerous. Be careful of fire
because the fuel is very likely to catch fire.

Refuel only after stopping the engine, and never leave open fuel
can near the machine. Do not spill. It could cause a fire. When it is
spilt, wipe it up completely.

Never use alcohol-base cleaning fluid. If it sticks to such parts
made of plastic, it causes degradation of liquid surface visibility,
and, in the worst case, can lead to cracking and result in fuel
leaks.
Check Fuel Pre-Filter Drain
If the red float [C] inside the fuel pre-filter is above line [B], drain water from the fuel pre-filter.
<Procedure>
1. Connect a hose to drain outlet [E] when drain.
2. Prepare a container. Loosen drain plug [D] and air
bleeder plug [F] to drain.
3. After draining finished, be sure to tighten [D] and [F].

Do not remove pre-filter case [A] as fuel is overflow if it
is removed. If it is necessary to remove it, plug inlet
hose with a clip etc.

Drain the condensate into a container, and then
dispose of condensate according to the designated
regulations.
F
A
B
C
D
E