Allmand Maxi-Power MP65 T4F, Operator'S Manual

Page: 47 / 76

Not for
Reproduction
47
Periodic Inspection
59
[How to use booster cable]
<Procedure>
1. Stop the engine.
2. Connect one end of the (+) booster cable to the (+)
terminal of the machine battery.
3. Connect the other end of the (+) booster cable to the
(+) terminal of the external battery.
4. Connect one end of the (–) booster cable to the (–)
terminal of the external battery.
5. Connect the other end of the (–) booster cable to the
engine block of the machine.
6. Start up the engine.
7. Disconnect the booster cable by following the
procedure back in the reverse order.

When a booster cable has to be used or when cables are connected again after a battery is replaced, be
careful not to connect (+) and (–) terminals backwards.
A backwards connection will cause sparking and damage to each component.
Check and Clean Air Filter Elements
Every 250 Hours
When the air filter monitor lamp glows, clean the air filter.
<Procedure>
1. After removing the cap [A] by loosening its cap fixing
latch [B], clean its interior properly.
2. Remove the element [C], and clean it.
3. When installing the cap after finishing the cleaning job,
push the element into the case [D] firmly by hand, and
then make sure that the cap fixing latches attach
securely to the case. Lastly, tighten the latches.

If the element is found heavily dusty, replace it with a
new one.

When an element that is clogged or has holes or cracks is used, dust or foreign material will get in the
engine. This causes accelerated wear in moving parts within the engine. Be sure to perform daily checks
and appropriate cleaning so that the life of the engine will not be shortened.
E C
D
B
A
To engine block
Internal battery
External battery