Allmand Maxi-Power MP65 T4F, Operator'S Manual

Page: 35 / 76

Not for
Reproduction
35
Operation
43

Do not under any circumstance, open the portions below during
operation.

Coolant drain valve

Engine oil drain valve

Never work nearby hot portions of the machine while it is running.

Do not touch hot portions of the machine while inspecting the
machine when running.

Parts such as the engine, exhaust manifold, exhaust pipe,
muffler, and radiator are especially hot. Never touch those
parts, because it could cause scalding.

Coolant water and engine oil are also very hot and dangerous to
touch. Avoid checking or refilling them while the machine is
running.

When the breaker functions often during operation, reduce the load.

When using 1-phase load, check the current of each phase and try to keep the load of each phase
constantly average.

If you continue to operate the generator while ignoring or neglecting these cautions, it could cause
overheating and result in fire. Furthermore, should operation continue at a lower level than the standard
rated frequency, it could burn the generator and any motors of the attached load.
Panel light

The panel is equipped with an LED light. Turn the panel light switch “ON” to use.

When illumination is not necessary, turn the light “OFF”. If the machine is always operated with the lamp
switched “ON”, the lamp life can be reduced.
Operating procedures when engine fails to start up on first attempt
If the engine repeatedly fails to start, the following causes are suspected. Check the following:

No fuel

Clogging of the fuel filter

Discharge of battery (Low cranking speed)