Not for
Reproduction
12 ALLMAND.COM
Read entire Operator’s Manual before you
attempt to setup, transport, or operate your
new towable generator.
Your towable generator is ready for use after it has
been properly setup with the recommended oil and fuel.
If you have any problems with the setup of your towable
generator, contact your authorized dealer
Transporting
WARNING
When loading and unloading the
unit, be sure to use the lifting bail (
B
) located at the top
center of the unit.
• Never get under the unit when lifted.
• Never lift the unit while in operation.
• If the unit is transported by truck, fasten it by
chains at the front eye and rear stand. Also be
sure ot place a set of chocks against the front and
rear of each wheel.
Lifting the Generator
Before lifting the unit, make sure to check the lifting
bail for any cracks, loose bolts, etc.
1. Connect the hook (
A
) of the crane or shackle with
the lifting bail (
B
) eye fitted at the top center of the
unit. Ensure there is no person standing around
the unit. Then perform hoisting operation.
2. Select a truck or crane with capacity sufficient
for the weight and size of the unit. See
Specifications
.
3. Never hang anything from generator while lifting.
Bail is designed to carry only weight of generator.
B
A
Towing the Generator
WARNING
Before towing the machine, make
sure to check and confirm the following points. Failure
to follow the instructions below, could result in serious
injury or death.
• Proper tire air pressure.
• Tire lug nuts are not loose.
• Tires are not worn or damaged.
• Ensure that the end of the drawbar is securely
connected to the coupler of the towing vehicle.
• Ensure there is no damage to the towing vehicle
and the drawbar of the machine.
• Be sure to keep hands and fingers away from
any part of the coupling device when coupling or
uncoupling a drawing device to a draw bar.
• Be sure the height of the hitch is adjusted so
that the trailer is level while connected to the tow
vehicle.
• Make sure to drive the towing vehicle safely.
Set-Up
WARNING
• Exhaust gas from the engine is poisonous, and could
cause death when inhaled.
• Do not operate the unit indoors.
• Do not position the exhaust gas outlet in the direction
of a person or building.
The machine should be operated in the following
conditons:
• Ambient temperature 5°F to 104°F (-5°C to 40°C).
• Humidity less than 85%.
• At altitudes lower than 3,281 ft (1000 meters)
above sea level.
• Set up the machine in a place with good
ventilation, lower temperature, and with
surroundings as dry as possible.
• If more than two machines are placed parallel in
operation, keep enough distance so that exhaust
air from one machine does not affect the other.
• Set up the unit in an area where fresh air is
always available.
• Keep enough space around the unit for inspection
and maintenance access.
WARNING
The machine must be parked
horizontally on a level surface. If the machine must be
parked on a slope, place it across the grade to prevent
rolling. Do not park on a slope exceeding 15°. Be sure
to place wheel chocks (
C
) against the front and back
of each wheel.
C
Transporting and Set-Up
Summary of Contents for Maxi-Power MP65 T4F
