Allied Telesis AT-ANC10S/4, Installation Manual

Page: 72 / 130

Chapter 6: Setting Advanced Properties
72
Interrupt
Moderation Enables interrupt moderation,
which limits the rate of interrupt to
the CPU during packet
transmission and packet
reception. The disabled option
allows one interrupt for every
packet transmission and packet
reception. Enable is the default
option. 1. In Microsoft Windows, right-
click the Network Adapter in
Network Connections, and
then click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Set the desired Interrupt
Moderation value.
Jumbo Packet Enables the network adapter to
transmit and receive oversized
Ethernet frames that are greater
than 1514 bytes, but less than or
equal to 9000 bytes in length
(9600 bytes for network adapters
that operate at 10 Gbps). This
property requires the presence of
a switch that is able to process
jumbo frames. This property is
only available for the ANC10S
network adapters. Frame size is
set at 1500 bytes by default. To
increase the size of the received
frames, raise the byte quantity in
500-byte increments. 1. In Microsoft Windows, right-
click the Network Adapter in
Network Connections, and
then click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Set the desired Jumbo Packet
value.
IPv4 Checksum
Offload Allows configuring checksum
offload for the IPv4 protocol. The
options are listed here:
Disable - Disables checksum
offload.
Rx Enabled - Enables receive
TCP/IP/UDP checksum offload.
Tx Enabled - Enables transmit
TCP/IP/UDP checksum offload.
TX & Rx Enabled (default) -
Enables transmit and receive
TCP/IP/UDP checks
1. In Microsoft Windows, right-
click the Network Adapter in
Network Connections and then
click Properties.
2. Click the Configure button and
then the Advanced tab.
3. Set the desired IPv4
Checksum Offload value
Table 8. Advanced Features in Microsoft Windows
Feature Description Configuration Steps