Chapter 10: User Diagnostics
112
Overview
Broadcom NetXtreme II User Diagnostics is an MS-DOS based
application that runs a series of diagnostic tests. These tests allow you to
update device firmware as well as to view and change settings for
available adapter properties.
Note
The diagnostics utility is available from the Allied Telesis web site at
www.alliedtelesis.com/support/software
.
To run Broadcom NetXtreme II User Diagnostics, you must create an MS-
DOS 6.22 bootable disk containing the uediag.exe file. Next, start the
system with the boot disk in drive A. See the following sections:
For a list of system requirements to run the diagnostic tests, see
“System Requirements” on page 113.
For instructions how to run diagnostic tests on the AT-ANC10S/2
and AT-ANC10S/4 adapters, see “Performing Diagnostics” on
page 114.
For descriptions of the available diagnostic tests, see “Diagnostic
Test Descriptions” on page 117.
Summary of Contents for AT-ANC10S/4
