AT-ANC10S/2 and AT-ANC10S/4 Adapters Installation and User’s Guide
33
Installing the Standard Bracket on the AT-ANC10S/2 Adapter
If you are installing AT-ANC10S/2 adapter in a computer that requires a
standard bracket, you must replace the pre-installed low profile bracket on
the adapter with the standard bracket. To install the standard bracket,
perform the following procedure:
Note
The AT-ANC10S/4 adapter comes with the standard bracket pre-
installed. It does not come with a low profile bracket because it
cannot be installed in a computer that accommodates only low-
profile adapters.
To replace the low-profile bracket with the standard bracket, do the
following:
1. Remove the screws that attach the bracket to the adapter. See
Figure 7.
Figure 7. Removing the Low-profile Bracket
2. Fit the standard bracket onto the adapter as shown in Figure 8 on page
34 and secure with the two screws.
Summary of Contents for AT-ANC10S/4
