Allied Telesis AT-9400, User Manual

Page: 346 / 668

Chapter 21: SNMPv3
346 Section IV: SNMPv3
Do you want to delete this table entry?(Y/N):[Yes/No]->
7. Enter Y to delete the view or N to save the view.
The following prompt is displayed:
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Access
Table Entry
This section describes how to modify parameters in an SNMPv3 Access
Table entry. For each entry in the SNMPv3 Access Table, you can modify
the following parameters:
ˆ
Read View Name
ˆ
Write View Name
ˆ
Notify View Name
ˆ
Storage Type
Configure the values of the Read View Name, Write View Name, and
Notify View Name parameters with values previously configured with the
View Name parameter in the SNMPv3 View Table. This is the only way to
associate a Group Name with these Views. See “Creating an SNMPv3
View Table Entry” on page 331.
See the following procedures:
ˆ
“Modifying the Read View Name” on page 346
ˆ
“Modifying the Write View Name” on page 349
ˆ
“Modifying the Notify View Name” on page 351
ˆ
“Modifying the Storage Type” on page 353
Modifying the Read View Name
To modify the Read View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type
5 -> 5 -> 5 .
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 4 to select Configure
SNMPv3 Access Table.
The Configure SNMPv3 Access Table is shown in Figure 131 on page
341.