Allied Telesis AT-9400, User Manual

Page: 334 / 668

Chapter 21: SNMPv3
334 Section IV: SNMPv3
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 View Table to the configuration file. After making changes to
an SNMPv3 View Table entry with a NonVolatile storage type, the
S -
Save Configuration Changes option appears on the Main Menu,
allowing you to save your changes. Allied Telesis recommends this
storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 View Table entry takes effect immediately.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 View
Table Entry
You may want to delete an entry from the SNMPv3 View Table. After you
delete an SNMPv3 View Table entry, there is no way to undelete, or
recover the entry.
To delete an entry in the SNMPv3 View Table, perform the following
procedure:
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type
5 -> 5 -> 5 .
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 3 to select Configure
SNMPv3 View Table.
The SNMPv3 View Table is shown in Figure 129 on page 332.
3. From the SNMPv3 View Table, type 2 to select Delete SNMPv3 Table
Entry.
The following prompt is displayed:
Enter View Name:
4. Enter the View Name of the View Table entry you want to delete.
The following prompt is displayed:
Enter View Subtree (OID format/Text Name):
5. Enter the subtree for this view.
Do you want to delete this table entry? (Y/N):[Yes/No]->