Allied Data Technologies TRON SECURE 33.6, Manual

Page: 20 / 63

AT\B Send a break to remote
During a non-error correction connection, the modem will send a break signal to the
remote modem with a length depending on the specified parameters. During an error
correction connection, the break will be sent by the active error correction protocol.
However, this will be done without an indication of the length. An ERROR will be given
when there is no connection or when the modem works in the FAX mode.
1 - 9 Break length in 100 ms units (default = 3).
(This only counts for non-er ror correction connections)
AT%C Select data compression mode
This command is used to select between MNP5 and/or V42bis.
This mode can only be used at a connection with error correction.
0 - data compression off
1 - MNP5 data compression on
2 - V42bis data compression on
3 - V42bis and MNP5 on, auto select (default)
AT&C Carrier Detect (DCD) status
Controls the function of the DCD signal.
0 - DCD is always on (not visible on LED)
1 - DCD follows the status of the carrier on the line (default)
TRON SECURE 33.6
Allied Data Technologies BV - Allways one step ahead 20