It is also necessary to connect all available water inlets to a water
supply. If a hard water supply is not present, connect it with soft
cold water. If no hot water supply is present, contact your dealer
for the proper required action.
WARNING
If the water pressure is below the minimum value,
the wash result can not be guaranteed for a selected
program.
W914
3 Water Connection Models
C-CZW5NA
2
3
1
1.
Refer to
.
2.
Refer to
.
3.
Refer to
.
Figure 25
Possible Water Connection Options
Water
Type
Water Connection
1
2
3
Cold and Hot
Cold
Hot
N/A
Cold soft,
Cold hard and
Hot
Cold soft
Hot
Cold hard
Table 19
To Install
1. Flush the water system in order to remove any particles that
may be in the water system.
2. Install on the washer the filter device, normally delivered with
the washer.
3. Connect to this the inlet water hose with appropriated seal
washer where necessary.
Connecting
2
4
7
C-CZW4N
1
2
6
5
3
1.
Rear bridge of machine
2.
Thread sealant (Loctite 55)
3.
To customer connection
4.
Hose
5.
Rubber washer
6.
Pipe Nipple (not valid for models for North America and
Australia)
7.
Filter (not valid for models for North America and Austral-
ia)
Figure 26
When connecting inlet hoses, be sure hose connections are not
cross-threaded on the connection devices. Tighten the hoses se-
curely. DO NOT over tighten as this will damage threads on the
device(s).
The water hardness can have an influence on the wash results.
The soap supplier can help you with making the right decisions
concerning hard water, soft water, washing programs, type of
soap and other related items to give the best wash results.
Hot Water
IMPORTANT - Temperature in Wash Tub
The electronic controller uses the temperature sensor in the tub to
control the temperature of the washing bath. There are a lot of
things that have influence on the temperature measurement.
Therefore the temperature control of the washing bath is not very
precise.
In principle, the manufacturer strives that the real temperature in-
side the washer is never higher than the programmed temperature
so that textile linen will not be damaged because of too high tem-
perature. If for certain applications a very precise washing bath
temperature is necessary, appropriate measures must be taken.
Refer to Programming Manual.
The manufacturer will refuse any responsibility for all conse-
quences because of inaccurate temperatures inside the washing
machine tub.
The hot water supply needs to be large enough to provide the re-
quired hot water for the installed washers. For good wash results,
we advise a hot water supply that is set between 158 - 176° F [70
- 80° C].
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
36
Part No. D2601EN
Summary of Contents for UY350 PROFORM TOUCH
Page 2: ......
