Alliance Laundry Systems UY350 PROFORM TOUCH, Installation Operation & Maintenance

Page: 27 / 63

Unpacking Steps - Machines with Front Tilting
CZW29NB
A
A B C D E
A - Step 1
B - Step 2
C - Step 3
D - Step 4
E - Step 5
Figure 10
1. After unpacking, check if the machine has not been damaged
and if all the accessories are included according to your order.
2. Verify the type of your machine by its serial plate and find the
corresponding information in the manual. The accessories are
delivered inside the machine drum.
3. Remove four nuts M10 from the front and rear part of the pal-
let. Remove both connecting beams of the pallet. Remove the
front cover of the machine. Use the room between both the
halves of the pallet for a hand pallet truck.
IMPORTANT: To prevent any damage of the sack lo-
cated in the middle of the machine (in its rear sec-
tion), it is only allowed to use a pallet truck the dis-
tance ‘A’ of which (i.e. the distance between its lift-
ing arms) is equal to or larger than 14.17 in. [360
mm]. Handle the machine with care, remember that
it is fitted with a air spring which is a sensitive com-
ponent. Refer to
Figure 11 .
CZW28N
X
Figure 11
4. Handle the machine with a forklift or with a hand pallet truck.
Make sure the fork does not damage components located in
the lower section of the machine. The lift truck or hand pallet
truck forks must be at least 3.94 in. [10 cm] longer than the
length of the washing machine frame, refer to
Table 10 . Lift
up the machine carefully, loosen the four nuts M16 and re-
move the rests of the pallet.
Models with Weighing System
The machine is positioned in special transport feet. Refer to Fig-
ure 12 and Figure 13 .
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
27 Part No. D2601EN