Installing Your PanelView 1200 Terminal
Chapter 3
3-7
Figure 1.7
Series E Logic Board with Jumpers JP1 and JP2 in the EPROM/EEPROM Position
20319
Node Adapter Firmware
System Firmware
User PROM
SYSTEM MEMORY
USER MEMORY
U2
JP2
JP1
7
Gently ease the chip’s pins into the socket.
Attention
The notch on the chip MUST be on the same end as
the notch on the socket.
Important
Series C and earlier PanelView 1200 terminals use two
PROMs as user memory. Series D and E terminals require one PROM to
achieve the same functionality. PanelView 1200 terminals prior to Series
D that have had the logic board replaced may also require only one
PROM depending on the revision of the logic board.
The PanelView 1200 terminal accepts either a 28-pin EPROM or a
32-pin EEPROM. The 32-pin socket in the terminal is large enough to
accommodate an EEPROM, as the following figure shows. If you find it
necessary to put a 28-pin EPROM into the 32-pin socket, be sure to
position the EPROM position the EPROM as far away from the notched
end of the socket as possible.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
