Installing the 2.5-inch hard-drive cage
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 2.5-inch hard-drive cage and provides a visual representation of the installation
procedure.
Steps
1. Insert the 2.5-inch hard-drive cage into its slot on the chassis.
2. Align the tabs on the cage with the tabs on the chassis.
3. Replace the two screws (#6-32) that secure the 2.5-inch hard-drive cage to the chassis.
NOTE: Repeat the procedure from step 1 to step 3 to install the other 2.5-inch hard-drive cage.
Next steps
1. Install the
, if required.
2. Install the
3. Follow the procedure in
After working inside your computer
.
3.5-inch hard-drive cage
Removing the 3.5-inch hard-drive cage
Prerequisites
1. Follow the procedure in
Before working inside your computer
2. Remove the
.
3. Remove the
25
Summary of Contents for Aurora R11
