Steps
1. Align the screw hole of the AlienFX LED board to the screw hole on the front bezel.
2. Replace the four screws (M3x4) that secure the AlienFX LED board to the front bezel.
3. Connect the AlienFX LED board cable from a Y-cable.
Next steps
1. Install the
2. Install the
.
3. Install the
4. Install the
5. Follow the procedure in
After working inside your computer
.
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
Before working inside your computer
2. Remove the
.
3. Remove the
4. Remove the
5. Remove the
About this task
The following images indicate the location of the power-button board and provides a visual representation of the removal procedure.
87
Summary of Contents for Aurora R11
