60
The tracks menu is used to select the track control method and to
allocate or map tracks to editor track enables.
The highest track available for track mapping is determined by the
number of ADATs connected. If a track previously mapped is no
longer available because the number of ADATs connected has
been reduced then the selected tracks will flash to indicate that they
are invalid.
Track mapping is only available when the AI-2 control source is set
for SONY editor control.
Menu
Submenu
Option
Description
TRACKS
All safe:
Off
On
Default
Sel:
Editor Map
Use track mapping assignments.
Lynx/MMC
TimeLine Ext controller or MMC.
Local
Track enable at machine front panel.
Mapping
Single
Any selected audio track.
A1-A2
A1/A2 to odd/even pairs, (default)
A1-A4
Any group of 4, 1-4 etc.
Da1-Da8
Any group of 8, 1-8 etc.
Map to:
Mapping table determined by mapping
variable above as follows, default to
lowest numbered selection..
Single
1, 2, 3, ..., 128
Odd/Evn
1-2, 3-4, 5-6, ..., 127-128
Grp of 4
1-4, 5-8, 9-12, ..., 125-128
Grp of 8
1-8, 9-16, 17-24, ..., 121-128
Rec Src:
Determines editor track source for
local track selection.
Any
Any track record enabled.
AudOnly
Any audio track record enabled.
A1
A2
A3
A4
Vid
•
All Safe. Used to put all ADAT tracks into safe. Any track
mapping configuration will be retained. Faster lock times can be
achieved if the AI-2 is set to all safe, this of course is only
possible if it is not intended to record on the ADAT transports.
