Alcatel-Lucent 7750 SR-OS, Configuration Manual

Page: 265 / 674

IP Router Configuration
7750 SR OS Router Configuration Guide Page 265
Inactive 107.0.0.1/32 mda-2-1
Inactive 108.0.0.1/32 mda-2-1
Inactive 109.0.0.1/32 mda-2-1
-------------------------------------------------------------------------------
No. of Routes: 10
===============================================================================
*A:Dut-C# show router 1 tms routes
===============================================================================
TMS Routes (IPv4)
===============================================================================
Status Network Next Hop[Interface Name]
-------------------------------------------------------------------------------
Active 100.0.0.1/32 mda-2-1
-------------------------------------------------------------------------------
No. of Routes: 1
===============================================================================
tunnel-table
Syntax tunnel-table [ ip-address [/ mask ]] [ protocol protocol | sdp sdp-id ] [ summary ]
Context show>router
Description
This command displays tunnel table information. Note that auto-bind GRE tunnels are not displayed in
show command output. GRE tunnels are not the same as SDP tunnels that use the GRE encapsulation
type. When the auto-bind command is used when configuring a VPRN service, it means the MP-BGP
NH resolution is refering to the core routing instance for IP reachability. For a VPRN service this object
specifies the lookup to be used by the routing instance if no SDP to the destination exists.
Parameters ip-address [ /mask ] — Displays the specified tunnel table’s destination IP address and mask.
protocol protocol — Dislays LDP protocol information.
sdp sdp-id — Displays information pertaining to the specified SDP.
summary — Displays summary tunnel table information.
Output Tunnel Table Output —
The following table describes tunnel table output fields.
Label Description
Destination
The route’s destination address and mask.
Owner
Specifies the tunnel owner.
Encap
Specifies the tunnel’s encapsulation type.
Tunnel ID
Specifies the tunnel (SDP) identifier.
Pref
Specifies the route preference for routes learned from the configured
peer(s).
Nexthop
The next hop for the route’s destination.