Alcatel-Lucent 7750 SR-a4, Installation Manual, Page: 224 / 232

Installation and Replacement of Pluggable Transceivers
224 7750 SR-a4 and SR-a8 Installation Guide
Installation and Replacement of Pluggable
Transceivers
The following sections describe how to install and replace the pluggable transceivers
supported on MDA-a cards.
An SFP module can be installed on the following MDA-a cards:
• 2-port 10GigE SFP+ and 12-port 1GigE SFP Combo MDA-a
• 44-port 1GigE CSFP/SFP MDA-a
An CSFP module can be installed on the following MDA-a card:
• 44-port 1GigE CSFP/SFP MDA-a
An SFP+ module can be installed on the following MDA-a and MDA-aXP cards:
• 2-port 10GigE SFP+ and 12-port 1GigE SFP Combo MDA-a
• 4-port 10GigE SFP+ MDA-a
• 6-Port 10GigE SFP+ and 1-Port 40GigE QSFP+ Combo MDA-aXP
• 10-port 10GigE SFP+ MDA-aXP
A QSFP+ module can be installed on the following MDA-a XP card:
• 6-Port 10GigE SFP+ and 1-Port 40GigE QSFP+ Combo MDA-aXP
A CFP module can be installed on the following MDA-aXP card:
• 1-port 100GigE CFP MDA-aXP
Installing an SFP, SFP+, CSFP, or QSFP+
To install an SFP, SFP+, CSFP, or QSFP+ transceiver:
Step 1. Locate the transceiver receptacle on the MDA-a card.
Step 2. Remove the transceiver from its antistatic packaging.
Step 3. While holding the transceiver by its sides, slide the unit into the port at the correct
angle. If other transceivers are present, you may need to push on the face to fully
seat the transceiver. The transceiver is seated when it clicks into place. See
Figure 84 . Table 112 describes the SFP installation features. The same features
apply to SFP+s and CSFPs.