7
terrace, make sure it is not directly exposed to atmospheric agents to prevent
any damage to components which would lead to a warranty invalidation. It is
recommended to provide the boiler with a protective casing/box against bad
weather conditions.
• Check the technical data reported on the packing and on the type label
stuck inside boiler. Also check that the burner is appropriate for the
type of gas to burn.
• Make sure that the pipes and fittings used for the gas service are
perfectly tight and that there are no gas leaks.
• Prior to start-up, the central heating pipes should be flushed to remove any
residues that could compromise the operation of the appliance.
• The appliance can be regarded as being electrically safe when it has
been connected to an efficient earth system installed in accordance with
the requirements of current safety standards. This fundamental safety
requirement must be checked and verified. In case of doubt, have the
electrical system checked by a qualified electrician. The manufacturer will
not be held liable for any damage or injury caused as a result of an ineffective
or non-existent earth system.
• The domestic power supply must be checked by a qualified electrician to
ensure that it can support the maximum power absorption of the appliance,
as indicated on the type label (stuck inside boiler). In particular, make sure
that the cable ratings are adequate for the power absorbed.
• Do not use adapters; multiple sockets or extension leads to connect the
appliance to the mains power supply.
• The appliance must be connected to the mains power supply through
an appropriate electrical isolator in accordance with the current wiring
regulations.
When using an electrical appliance, a few fundamental rules must be
observed:
• Do not touch the appliance with damp or wet parts of the body or when
barefoot.
• Do not pull on the electric wires.
• Do not leave the appliance exposed to atmospheric elements (rain, sun,
etc.).
• Do not allow the appliance to be used by children or anyone unfamiliar with
its operation.
• The user must not replace the power supply cable.
• If the cable is damaged in any way, switch off the appliance and have the
cable replaced by a suitably qualified electrician.
Summary of Contents for SUPER FIT 24
