Alarko SUPER FIT 24, Assembly, Installation And Operation Instructions

Page: 41 / 56

41
In case of doubt, have the electrical system checked by a qualified electrician.
The manufacturer will not be held liable for any damage or injury caused as a
result of an inefficient or inexistent earth system.
■ The boiler functions with an alternating current of 230 V and 50 Hz and
has maximum power absorption of 82/84/117 Watt for SUF 24/28/35 in
sequence. The appliance should be protected by a 3 A fuse. Make sure that
the positions of the live and neutral wires correspond to the wiring diagram.
■ Ensure the domestic power supply is checked by a qualified electrician to
ensure that it can support the maximum power absorption of the appliance,
as indicated on the rating plate. In particular, make sure that the cable sizes
are adequate for the power absorbed by the appliance.
■ The power supply cable must not be replaced by the user. if the cable is
damaged in any way, switch off the appliance and have the cable replaced
by a suitably qualified electrician.
■ When replacing the power supply cable, only use cables of the same
characteristics.
When using an electrical appliance, a few fundamental rules must be
observed:
■ Do not touch the appliance with damp or wet parts of the body or when
barefoot.
■ Do not pull on the electric wires.
■ Do not leave the appliance exposed to atmospheric elements (rain, sun,
etc.) unless these conditions have been expressly provided for.
■ Do not allow the appliance to be used by children or anyone unfamiliar with
its operation.
ATTENTION!
The manufacturer shall not be held responsible for damage to property
and life caused by the lack of an effective grounding system.
In buildings without a grounding line, if there is an application where
neutral and ground connection is combined, the device should never
be connected to this line. If connected, the manufacturer cannot be
held responsible for damage to property or life.