Alarko SUPER FIT 24, Assembly, Installation And Operation Instructions

Page: 11 / 56

11
your own safety, do not ask the installer to install your boiler to prohibited
spaces.
• Before gas installation, a suitable gas installation project has to be prepared
and approved according to the requirements of local gas distribution
organization. After approval of local gas distribution organization and
precise application of installation, have your boiler commissioned by an
Authorized Service. Commissioning is a free service.
• Do not let unauthorized people to interfere or service the boiler.
• Gas conversion process (from natural gas to LPG or from LPG to natural
gas), if necessary, must be made by an authorized service only. Conversion
is paid by the end-user.
• Keep flammable and combustible objects, either liquid or solid, away from
the boiler.
• Do not use any spray, chemical solvent, chlorinated cleaner, paint or
adhesive near the boiler.
• Do not place cooker near the appliance and protect the boiler from direct
vapor. The boiler is to be connected to an earthed 230 V - 50 Hz electric
supply.
• To enable the frost protection function in winter when the weather temperature
might fall below 0°C, do not turn the boiler off. This function is active only if
the combi boiler and gas valve are in ON condition. Manufacturer does not
take any responsibility for the damage caused by neglecting this rule.
• Filter must be installed at the water inlet of the boiler to protect the pump
and the filter must be cleaned periodically. Apply the authorized service to
take more information about this process.
• If you charge the central heating system with hard water, this may cause
blockage of DHW heat exchanger. Domestic hot water should not exceed
17,5 French hardness value.
Domestic hot water circuit does not need a safety valve. On the other hand,
pressure should not exceed 10 bar. In case of doubt, a pressure regulator
should be fitted. Consult your installer on this issue.