AL-KO solo 127448, Original Instructions Manual

Page: 12 / 68

12
EN
1 - 3 mm
D
E
Adjust Throttle lever (E) so that choking works when it is positioned at " ".
1.
2.
3.
If adjustment is necessary,
adjust by turning Adjuster (i),
loosening Lock nut (j) of
Gearshift wire (d).
Set to the optimal position and
tighten Lock nut (j).
Start the engine and confirm
that running speed changes
when Gearshift lever (D) is
operated.
NOTE
Adjust the play of Gearshift lever (D) to 1 - 3 mm as shown in Fig. 26.
Ask our distributor for adjustment if the machine does not operate properly
even after adjusted by the above-mentioned methods.
Gearshift Lever
B
C
a
b
c
d
h
g
e f
k i
l
j
75 - 100 mm
Adjust so that the machine runs
(the drive clutch gets engaged)
when the distance between
Drive clutch lever (B) and the
handle is 75 - 100 mm as
shown in Fig. 25.
1.
2.
3.
4.
1.
2.
3.
Adjustment of Wires
Poor adjustment of each wire will result in the decline of performance or a
machine failure.
NOTE
Confirm that the adjustment
hole on the engine control panel
matches Throttle lever (E) when
the lever is set at high speed
position " ".
If adjustment is necessary,
adjust by turning Adjuster (g),
loosening Lock nut (h) of
Throttle wire (b).
Set the adjuster to the optimal
position and tighten Lock nut (h).
Start the engine and confirm that
the engine stops completely when
Throttle lever (E) is set at " ".
If adjustment is necessary, adjust by turning Adjuster (e), loosening
Lock nut (f) of Blade wire (a).
Set the adjuster to the optimal position and tighten Lock nut (f).
Confirm that the blade stops completely when Blade lever (C) is
released.
Throttle Lever
Blade Lever
1.
2.
3.
If adjustment is necessary, adjust by turning Adjuster (k) , loosening
Lock nut (l) of Drive clutch wire (c).
Set the adjuster to the optimal position and tighten Lock nut (l).
Confirm that the machine can be pull backward when Drive clutch
lever (B) is released.
Drive Clutch Lever
Adjust so that the blade starts
rotating when the distance
between Blade lever (C) and
the handle is 50 - 75 mm with
the yellow button pressed as
shown in Fig. 24.
50 - 75 mm
(See Figs. 22 and 26)
(See Figs. 22 and 25)
(See Figs. 22 and 24)
(See Figs. 22 and 23)
Fig. 26
Fig. 25
Fig. 24
Fig. 23
Fig. 22
8.5.1
8.5.2
8.5.3
8.5.4
8.5
EN