AL-KO solo 127448, Original Instructions Manual

Page: 11 / 68

11
EN
1.
2.
3.
4.
Adjust the mowing height with the mowing height adjustment levers on
the wheels.
Adjustment of Mowing Height
Stop the engine.
Lean the mowing height
adjustment lever (H) toward the
wheel side, separating from the
notches (dents) (Z).
Insert the mowing height
adjustment lever (H) into the
notch (Z) for the target height
with the lever kept leaned.
Insert all Mowing height
adjustment levers (H) into the
notches (Z) of the same height.
Take caution not touch the muffler and the engine when adjusting
the mowing height adjustment levers on the front wheels.
Operation (Mowing and Running)
Operate each lever securely.
Before working, fully understand the contents of the safety
instructions including those in Section 3.
Push down each lever until it touches the handle. Continuing to
work with each lever not pushed down completely will result in a
machine failure.
Perform the inspection before
operation.
Set Throttle lever (E) to " " to
start mowing.
Push Blade lever (C) forward
while pressing its yellow button.
Then, the blade starts rotating.
Perform mowing work correctly and safely by observing the instructions in
this manual.
Use this machine at ambient temperatures between 5°C and 40°C.
Failure to use this machine within this temperature range may result in
malfunction, breakdown, or accident.
To interrupt mowing work halfway
or finish it, return Drive clutch
lever (B) and Blade lever (C),and
then set Throttle lever (E) to " "
to stop the engine.
1.
2.
3.
4.
Z
H
H
Z
B
Push Drive clutch lever (B)
forward to start mowing.
C
C
6.
Z
H
Adjust the mowing speed with
Gearshift lever (D).
5.
Adjust the mowing speed according to the conditions of the mowing area
and the grass.
The blade does not rotate for safety when Blade lever (C) is operated with
its button not pressed.
NOTE
SLOW FAST ←→
E
D
E
(See Section 8.1)
(See Figs. 20 and 21)
(See Fig. 19)
(See Fig. 18)
(See Fig. 17)
( See Fig. 16)
( See Fig. 15)
Fig. 21
Fig. 20
Fig. 19
Fig. 18
Fig. 17
Fig. 16
Fig. 15
8.3 8.4
EN