AL-KO solo 127448, Original Instructions Manual

Page: 9 / 68

9
EN
7.3 Attaching and Detaching of Grass Bag
7.1 Assembly and Height Adjustment of Handle
7. ASSEMBLY
a) Assembly instructions, initial adjustments and checks.
Please refer to follows.
b) Transport, handling and storage of the lawnmower.
Please refer to follows.
c) Preparation of the lawnmower.
Please refer to follows.
d) Information regarding the lawnmower.
Please refer to follows.
3.6.4 Inspection and Maintenance
7. ASSEMBLY
9. INSPECTION AND MAINTENANCE
3.6.5 Transportation by Car
9. INSPECTION AND MAINTENANCE
10. TRANSPORTATION
11. LONG-TERM STRAGE
8. OPERATION
9. INSPECTION AND MAINTENANCE
3. SAFETY
4. NAME AND FUNCTION OF EACH PART
e) The use of the lawnmower.
Please refer to follows.
f) Maintenance of the lawnmower.
Please refer to follows.
3. SAFETY
8. OPERATION
9. INSPECTION AND MAINTENANCE
3. SAFETY
8. OPERATION
9. INSPECTION AND MAINTENANCE
7.3.2 Removal
7.3.1 Assembly
・
・
Be sure to stop the engine. Open or Close Guard (G) slowly. Also,
do not insert your fingers in between.
NOTE
1.
2.
1.
2.
Lift Guard (G), and set Hook (W)
on the housing.
Confirm that Grass bag (F) is
attached at the specified
position.
Lift Guard (G), and remove
Hook (W) from the housing.
Close Guard (G) slowly.
Clogging of the grass bag
lowers the collecting perfor-
mance.
A wet grass bag advances
clogging.
CAUTION
G
G
F
W
(See Figs. 3, 4 and 5)
Fig. 5
Fig. 4
Fig. 3
Install the lower handle to
the machine (with 2 knob
nuts).
Assemble the upper handle
to the lower handle, and
then tighten with bolts and
knob nuts.
1.
2.
・ Fix wires, etc. to the handle with wire bands so that they do not
interfere opening / closing of the guard or operation of the machine.
NOTE
Wire bands
Wires
Tube
Lower handle
Upper handle
Knob nut
Knob nut
The handle can be adjusted steplessly within its adjustment range.
handle height adjust bolt
(See Figs. 1 and 2)
Fig. 2
Fig. 1
7.2 Assembly and Height Adjustment of Handle
The handle can be adjusted steplessly within its adjustment range.
handle height adjust bolt
Install the lower handle to
the machine (with 4 nylon
nuts).
Assemble the upper handle
to the lower handle, and
then tighten with bolts and
cap nuts.
Remove the housing bolts
and loosely fix the bar
temporarily.
Install the fixing band to the
lower handle.
Catch the bar with the
hanger band and tighten it
with bolts and cap nuts.
Tighten the bolts of the
housing.
・
・
Fix wires, etc. to the handle with wire bands so that they do not
interfere opening / closing of the guard or operation of the machine.
When adjusting the height of the handle, loosen the bolt of the
handle assist bar before loosening the handle height adjust bolt.
NOTE
Handle assist bar
1.
2.
3.
4.
5.
6.
Lower handle
Upper handle
Nylon nuts
Tube
Cap nuts
Wire bands
Wires
Fig. 1
Fig. 2
Fig. 3
Fig. 4
(See Figs. 1, 2 and 3)
(See Figs. 4)
553 K
548 K
EN