124
Chapter 13: Using the effects
■
If you selected Insert effects
1. Select TRACK MIX channels in Mixer mode, and adjust the AUX SEND-A or AUX SEND-B level of the
channel to which you wish to apply effects.
At this time, you can check the output level of AUX SENDs A/B using level meters SA/B.
2. Recall the
AUX-A PRE/POST
and
AUX-B PRE/POST
parameters to select
PRE
(pre-fader) to send
channel signals to the Insert effects.
3. Recall the
LEVEL
parameter, and set the level of the channel signals sent to the Insert effects to 0.
Now signals to which you wish to apply Insert effects are sent from the channel pre-fader position to AUX
SENDs A and B, but they are not output at the master L/R.
Adjusting the effect return level
You can adjust the level, pan, and
EQ
parameters for the effect return signals sent to the mixer section in the
THRU MIX channels of Mixer mode. Follow the steps below to adjust the level of the effect return signals.
1. Switch to THRU MIX channels in Mixer mode, and recall the
LEVEL
parameter.
2. Select the THRU MIX channels to which the effect return signal is routed, and raise the
LEVEL
.
If you selected
2 STEREO PAIRS
in Assign mode, you can adjust the effect return level of EFFECT A on
THRU MIX channels 3 and 4, and the level of EFFECT B on THRU MIX channels 5 and 6.
If you selected a Global effect, you can adjust only the level of the effect sound on THRU MIX channels. This
effect sound will be mixed with the dry sound of the TRACK MIX channels, and output from the MASTER
OUT jack and OPTICAL OUT jack.
If you selected an Insert effect, you can adjust the level of the mix of the dry and effect sounds. These signals
are mixed with the sound of other tracks on TRACK MIX channels, then output from the MASTER OUT and
OPTICAL OUT jacks.
➸
NOTE :
Make sure that the level of AUX SEND A (when EFFECT A is used) or AUX SEND B (EFFECT
B is used) is set to
0
on the THRU MIX channels to which the effect return signals are input. If the level is
set to any value other than
0
, the signals will loop.
✐
TIP :
Refer to page 58 for more information on operations in Mixer mode.
Summary of Contents for DPS12
Page 12: ......