Airxcel Aqua-Hot 600 Series, Installation Manual

Page: 8 / 63

Support and Clearance
©Aqua-Hot® 600D Installation Manual p. 7
Installing the Mounting Tray & Aqua-Hot
Install the Aqua-Hot in a compartment that is completely
closed off from living quarters and is accessible only from the
exterior of the coach.
1. Reference the following illustrations below for mounting
information.
2. Cut out the required mounting tray as shown in Figure 10.
3. Install the mounting tray fl ange into the cut out opening.
Reference Figure 11.
4. Insert a #10 machine screw into each of the embossed
holes in the mounting tray (6 total), and tighten to secure
the mounting tray to the coach.
NOTE: Inspect the area near the mounting location to
ensure that no structural members will interfere with
the cut-out for the mounting tray.
Figure 10
NOTE: The Aqua-Hot must be
supported by structural cross-
members that can support at least
185lbs.
5. Secure the mounting tray into place prior to installing the
Aqua-Hot.
6. Place the Aqua-Hot securely into the mounting tray to
ensure that the unit does not move or shift under normal
operating conditions. Reference Figure 12.
Figure 12
Figure 13
NOTE: Remove the bolt securing the front of
the access cover to the mounting tray. This
bolt will need to be reinstalled once the total
installation procedure is complete.
Figure 11