Airxcel Aqua-Hot 600 Series, Installation Manual

Page: 33 / 63

Introduction to Wiring
©Aqua-Hot® 600D Installation Manual p. 32
J2
The J2 Plug is responsible for managing return signals from
within the coach.
Pin Number Description Wire No.
J2-1 Pump 1 Output (12 V DC+) 5
J2-2 Pump 1 Ground 6
J2-3 Zone 1 Boost Pump -
J2-4 Pump 2 Output (12V DC+) 3
J2-5 Pump 2 Ground 4
J2-6 Power On Signal 24
J2-7 Pump 3 Output (12V DC+) 1
J2-8 Pump 3 Ground 2
J2-9 Zone 2 Boost Pump 39
J2-10 Pump 4 Output (12V DC+) 7
J2-11 Pump 4 Ground 8
J2-12 Electric Element On-Signal 11
J2-13 AC Ground 12
J2-14 Burner Ground 21
J2-15 Diesel Burner Status Input 19
Figure 60
Aqua-Hot Reporter
1
J2 Wire Insertion View Shown
2 3
4 5 6
7 8 9
10 11 12
13 14 15
J3
J3 serves as the RV-C connection to the coach-
side comfort system (if applicable). The RV-C
indicator light located on the back of the Reporter
serves as a valuable diagnostic tool when the need
to determine RV-C functionality arises.
Wire Insertion View Shown
J3 Pin No. Description
1
2
3
4
12V DC+ Current Out (Optional)
CAN-HIGH
CAN-LOW
Ground
Figure 58
The J3 plug connects to the on-board RV-C system of the coach
(if applicable). The RV-C indicator light located on the back of
the Reporter serves as a valuable diagnostic tool when the
need to determine RV-C functionality arises.
The J3 Plug is a 4-pin connector with self-contained power pins.
See the diagram below for the crimping information for the J3
plug. Crimp these parts together using pliers.
Manufacturer Part No. Description
3M
37401-2165-
000 FL 100
4-Position Plug (Male)
3M
37104-2165-
000 FL 100
4-Position Receptacle Plug
(Female)
General
Cable
E2104S.41.02
4COND 22AWG WHT SHLD
Cable
The parts listed above can be purchased from any major
electronics retailer. Only the parts listed above are approved for
use in the Aqua-Hot.
12V DC Power (J3-1)
Ground (J3-4)
Data (J3-2, J3-3)
Figure 59