73
2. Pipe connecting position and removal direction
(1) Pipe connecting position and removal direction
The figure shows units with capacity below 16HP. Units with capacity above 18HP share the same pipe
connecting position and removal direction only except for height.
Size in [ ] is for units with capacity above 18HP.
Drainage
pipe
D (left)
7-section
check opening
Terminal board for signal
line connecting
Terminal board for power
line connecting
D (front)
C (front)
C (right)
D (right)
C (back)
Back
Connector size of refrigerant pipe
(plane graph)
Back
Base removal position
Marks
A: Refrigerant pipe connector at gas side
B: Refrigerant pipe connector at liquid side
C: Refrigerant pipe outlet (Ø88 or Ø100)
D: Power line outlet (Ø50)
E: Power line removal opening (slot hole 40 × 80)
F: Hole for handling and hoisting
G: Balancing oil pipe connector
Balancing oil pipe of connect G is only for outdoor
combined units.
(Not required in case of single unit.)
Unit below: mm
Summary of Contents for AWAU-YDV1010-H13
