65
9.3 Installation location
Please obtain user's consent for selection of installation location.
Selection of installation location
Installation space (maintenance space) example
○ The place without air trapping.
○ Install the unit body in the firm position.
○ The place where air inlet and air outlet is free of ventilation obstacle.
○ The place is free from heat radiation of other heat sources.
○ The place where exhaust port will not be subject to strong wind.
○ The place where electrical noise is not subject to strict restrictions.
○ The place with sound drainage.
○ The place where noise and hot air will not produce negative impact to the neighbors.
○ The place that will not be buried by snow.
○ More than 5m away from the TV set and the radio.
(Far away from electromagnetic interference as much as possible.)
Warning:
(A) Install wind adapter in case of possible short circuit.
(B) In order to avoid short circuit, ensure sufficient inlet air space when installing multiple units.
(C) When using the unit in snow area, install stand and snow mantle to avoid the snow burying the unit body. (Don't
adopt centralized drainage in snow area.)
(D) Don't install the unit in place subject to possible leakage of flammable gas.
(E) Install the unit in a firm position which can bear the unit weight.
● Please consult the retailer for wind adapter, snow mantle, supporting components for centralized drainage and
other separately sold parts.
Attention
Please make sure to provide sufficient installation space.
Otherwise, the compressor and instrument may be failure due to short circuit.
Guarantee maintenance space (space for maintenance, passage, air duct and pipe placement).
(Consult with the retailer or the company in case of not meeting installation conditions as shown in the figure.)
Note:
1. The top of the outdoor within 2000 mm can not have obstructions; if there is an obstacle within 2000
mm must instal duct and ensure the air-out unobstructed, inlet air and return air don't short circuit.
2. The height beween obstacles around the outdoor and the bottom of the outdoor should be under 800
mm.
3. If the space is enough, for ease of maintenance, increase the distance between outdoors and the
outddor and the walls.
Summary of Contents for AWAU-YDV1010-H13
