5. Console Management in SNMP-FSH2602MG v2
AirLive SNMP-FSH2602MG v2 User’s Manual
84
enable, the packets queued exceed will be drop. Press
Space
key to set the time. This
valid value is 1sec, 2sec, 4sec and off. Default is off.
Low Queue Delay Bound:
Limit the low priority packets queuing time in switch. If
enable, the low priority packet stays in switch exceed Low Queue Max Delay Time, it
will be sent. Press
Space
key to enable or disable this function.
Low Queue Max Delay Time:
To set the time that low priority packets queuing in
switch. Default Max Delay Time is 255ms. The valid range is 1~255 ms.
NOTE:
Make sure of “Max bridge transit delay bound control” is enabled before enable Low
Queue Delay Bound, because Low Queue Delay Bound must be work under “Max bridge
transit delay bound control” is enabled situation.
Collisions Retry Forever:
Disable – In half duplex, if happens collision, the switch will
retry 48 times and then drop frame. Enable – In half duplex, if happens collision, the
switch will retry forever
Hash Algorithm:
This Hash Algorithm is for hardware maintaining on MAC table
calculation. Provide CRC or Direct Map
IFG compensation:
Disable or Enable
IP Stacking Group ID (0…65535):
assign the stacking group ID. The switches must
assign the same stacking group ID to be stacked as a group.
IP Stacking Mode:
enabling/disabling the stacking function. There are three stacking
modes. Any port on the switch can be used to stack. To configure the switch in stacking
group, please use the Web GUI configuration interface.
z
Disable:
The stacking function is not working.
z
Master:
There must have a leader switch to control all other switches in stacking
group. You can only assign one switch to be the master switch in one stacking
group. When the stacking group is set up, the master switch will control all
switches in the stacking group.
z
Slave:
besides the master switch, rest of the switches are called slave switch in
stacking group. When the stacking group is set up, you can only configure the
slave switches through the master switch.
Note:
1. Before configuring the stacking function, make sure all stack switches are in the
same network.
2. Configure stacking function; you must configure the master switch first.
3. After you have configured the stacking function, use Cat. 5 cable to connect every
switch in the stacking group.
4. To remove the switch from stacking group, you must remove the salve switch first.
When all slave switches are removed, you can remove the master switch from
stacking group.
Summary of Contents for SNMP-FSH2602MG V2
Page 1: ...SNMP FSH2602MG v2 24 2 port Mixed Gigabit SNMP Managed Switch User s Manual ...
Page 111: ...5 Console Management in SNMP FSH2602MG v2 AirLive SNMP FSH2602MG v2 User s Manual 106 ...
Page 128: ...7 Application Example IGMP Snooping 123 AirLive SNMP FSH2602MG v2 User s Manual ...
Page 134: ...9 Specifications 129 AirLive SNMP FSH2602MG v2 User s Manual Dimensions z 440 x 161 x 44 mm ...