72
BluCube Installation and Maintenance Manual 7222094 V1.12.0_04_2016
Network Display
The user will be able to view all modules connected to the AIRELAN.
By pressing + buttons, you can access each controller connected to the AIRELAN.
The display will show the unit number it is currently viewing at the top right-hand corner of the screen. (Examples
All the controllers connected to the AIRELAN network are identified using their own individual address. If duplicate addresses are used
the network will not work.
Addressing the Display Keypad
The address of the display keypad can be configured only after having connected the power supply, using the RJ11 connection cable.
To access the configuration mode, press the + + buttons simultaneously and hold them for at least 5
seconds; the screen shown above will be displayed, with the cursor flashing in the top left corner.
To change the address of the display keypad (display address setting), press the button once.
The cursor will move to the address field (
).
Use the or buttons to select the desired value, and press again to confirm. The display below confirms
that the address has been successfully changed.
Note: If the field “
” is set to
, the terminal will communicate with the pCO board using “point-to-point” protocol (not
pLAN). The field “I/O Board address: xx” will not be displayed, as this is not used with P2P protocol.
BluCube™
Condensing Unit
Te
ch
ni
ca
l
Summary of Contents for BluCube CUR092V16-1CO-0
Page 90: ......
