75
BluCube Installation and Maintenance Manual 7222094 V1.12.0_04_2016
Programming the Remote Display Keypad to the Controller
In the situation that the terminal display address is required to be set up, the following procedure applies.
Set the correct address on the display, connect to the controller and then power up the unit.
By simultaneously pressing and holding + + , the display will show the Display Address screen.
Pressing will change the I/O board address to the controller address 1.
Press . The following screen will be displayed:
Press again. The display will show the following terminal configuration screen:
Selecting Terminal 1 – Press until the cursor is underneath
Pressing or will change the 00 to the required value 32.
Setting Private to Shared – Press until the cursor is underneath the Pr (PRIVATE) symbol.
Pressing or will change the
to
(SHARED) symbol.
Press until the cursor is underneath the NO.
Pressing or will change the NO to YES. Press and the display is programmed.
Condensing Unit
BluCube™
Te
ch
nic
al
Summary of Contents for BluCube CUR092V16-1CO-0
Page 90: ......