Air-Vac PCBRM15, User Manual

Page: 77 / 120

Pcbrm15 & PCBRM System 5.2 User’s Manual Chapter 5: Maintenance/Parts
Part No. 4005.00.906
5-9
•
Locate the level in the carrier arm as if it were a PCB. Note the position of the bubble. Place the level
on the pump housing stack the same way. Note the difference between the two bubbles. Determine
which two leveling screws will need to be adjusted and by how much.
Note:
THE PUMP HOUSING STACK MUST BE PARALLEL TO THE CARRIER ARMS. THEY DO
NOT NEED TO BE LEVEL. LEVELING THE MACHINE IS THE NEXT STEP
•
Re-check the level of the pump and lock down the (4) lock nuts. DO NOT OVER TIGHTEN.
Machine Level:
•
Next level the machine , place level on the solder pump and level the machine on a
workbench. Bring the bubble dead center in both x and y positions by using the machine
legs. Once level has been achieved, lock legs in place with jam nut.
Level located in the carrier arms
Level located on the solder pump