Air-Vac PCBRM15, User Manual, Page: 20 / 120

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 2: Requirements/Machine Overview
Part No. 4005.00.906
2-6
(L)
(M)
(K)
(C) (E) (F) (G) (I) (J) (B)
(A)
(Q)
(P)
(R)
(O)
(N)- option
(Q)
(H)
(D)
(E) Main Power Switch – ON/OFF provides electrical power to the systems.
(F) Relatch Switch – Resets Main Power after unit is turned off or Emergency stopped.
(G) White Light – Indicates Main Power is on.
(H) Transformer Breakdown Light – Indicates failure of transformer coil isolation.
(I) Green Light – Indicates solder is molten and the machine is ready to cycle.
(J) Cycle Switch – Activates the Cycle Duration with Mode Switch in Automatic Mode.
(K) Temperature Controller – Controls temperature of solder.
(L) Ramp Up Flow Rate - Adjusts motor start speed of the pump, either quickly or slowly. To increase
ramp time, turn knob counter-clockwise. To decrease, turn clockwise.
(M) Ramp Down Flow Rate - Adjusts motor stop speed of the pump, either quickly or slowly. This can
help to produce a better solder joint. To increase ramp time, turn the knob counter-clockwise, to
decrease turn clockwise.
Note:
F
LOW
R
ATE INFLUENCES THE TOTAL DURATION
/
PROCESS CYCLE
. R
AMP
D
OWN
F
LOW
R
ATE
INFLUENCES THE TIME WHEN THE AIR IS ACTIVATED FOR THE AIR CLEANING SYSTEM
(APS
O
PTION
). F
OR SOLDERING
,
SET
R
AMP
D
OWN TO
"0". F
OR DESOLDERING
,
SET TO
"10".
(N) Flow Well Heater Box (option) – When external heaters are required for heating large flow wells.
(O) Heater Control Right (high/low) – Adjusts right flow well heater from low to high temp.
(P) Heater Control Left (high/low) – Adjusts left flow well heater from low to high temp.
(Q) Left & Right Plugs – Plug heater for flow wells here.
(R) ON/OFF Switch