- 26 -
After confirming the NOK ("CONFIRM OK" display),
the fastener must be unfastened prior to the next
release.
The rotation direction switch is set to counter-
clockwise rotation, and unfastening is not
allowed. The NOK-screwing in front needs to be
acknowledged. This can be programmed in the
settings with the AcraDyne Tool Manager.
Status display
Battery was installed, tool starts, but cannot
connect to the network. Press the trigger to start
a new connection.
Current redundancy of the torque was too high.
Current redundancy of the torque was too low.
The fastener must be inspected after a fastening
process. A time frame for this can be set (e.g. 15
seconds) and confirmed on the display. The timer
runs backward to its reference point. (Graphic stops
at 10.9 seconds.) If the fastener is not confirmed
within the set time, NOK is automatically selected.
The tool needs to be calibrated and will be
released after calibration.
The tool must be serviced and will not be
released until after the confirmation from service
personnel.
