Agrisem 5 Series, User Manual, Page: 36 / 130

User manual
Safety instructions
36
ChC_Safety_B-GB
06/12/2019
- Switch off the tractor engine, remove the ignition key, wait for all of the moving parts to come to a stop and
engage the hand brake.
- Set the machine on the ground, depressurise the hydraulic circuit and allow the machine to cool down.
- Secure the machine or elements that are in a raised position to avoid any accidental lowering.
- Chock the machine.
If using a high-pressure washer or steam cleaner, it is essential to comply with the following points:
- Do not clean the electrical and hydraulic components.
- Never direct the high-pressure washer or steam cleaner nozzle directly at the lubrication points or bearings.
- Systematically keep the nozzle a reasonable distance from the machine.
- Comply with the rules for using high-pressure washers.
Wear appropriate personal protective equipment for the work to be performed. In particular, wear safety shoes
and gloves to handle sharp parts.
Take all of the necessary precautions when fitting working parts that are both heavy and sharp.
The machine must be used, serviced and repaired only by competent persons who are familiar with the
machine's features and operation.
The machine must only be repaired with original AGRISEM INTERNATIONAL parts.
Protect bare metal parts using either thick grease or an anti-rust product that leaves a greasy film.
According to the type of machine: before carrying out any work on the electrical circuit or before any welding
operations, disconnect the wiring harnesses coming from the tractor. Disconnect the battery and alternator
cables.
5.1.6. Do not weld or use blow torches near pressurised fluids or inflammable products. Instructions
regarding installation
The machine may be fitted with electronic components and elements which may be affected by electromagnetic
emissions from other devices. This type of interference may be a source of danger for people if the following
safety instructions are not followed:
- If electrical components and/or devices are installed on the machine and connected to the on-board
electrical circuit at a later date, the user must first check that installing these items will not interfere with
the vehicle's electronics or other components.
- Ensure that electrical and electronic components subsequently installed comply with the current version of
electromagnetic compatibility directive 2004/108/EEC and that they have a CE marking.
Before carrying out any work on the electrical system, disconnect the battery's negative terminal.
Only use the recommended fuses. Using fuses of unsuitable capacity may damage the electrical system and
create a risk of fire.
Always comply with the safety rules for carrying out work on a machine fitted with a battery. Refer to the user
instructions of the machine concerned for more details.
5.1.7. Instructions regarding the hydraulic system
If your machine is fitted with a hydraulic circuit, the following instructions must be followed:
The machine is powered by pressurised hydraulic energy. Working on a pressurised circuit may give rise to
risks of injury by contamination. All operations must be carried out by professionals trained to handle hydraulic
technical equipment.
Contact the AGRISEM INTERNATIONAL customer service department for the replacement of any hydraulic
components.
Mark the sockets and connectors of the hydraulic connections between the tractor and the machine to avoid
handling errors. Refer to “Operation”, page 48 for more details.