Wireless Remote Base Unit for VS Series and G8610, G8611, or G8612 Series Leak Detectors
Page
4
of 14
Document No.
699910002
Revision
D
1) Turn off the power switch located on the back of the unit and unplug.
2) Wait 30 seconds for the high voltage to dissipate.
3) Using an extended length M5 Allen wrench, remove the four screws holding the rear plastic cover (Figure 1: Rear
and Front Cover Screws) and detach the rear plastic cover from the unit.
4) Remove the four screws holding the front plastic cover and detach the cover from the unit. Two screws are
situated at the front of the unit (not shown) and two screws are positioned inside the unit (Figure 1: Rear and
Front Cover Screws).
Figure 2: Fan Assembly and Socket Head Cap Screw
5) Disconnect the fan connector from the 24 V cable harness.
6) Detach the fan assembly by removing the M4 socket head cap screw and loosening the two wing nuts (Figure 2:
Fan Assembly and Socket Head Cap Screw). Place the fan assembly on a flat surface on its back.
Figure 3: Wireless Antenna
7) Hand tighten the antenna to the fan bracket, and then apply a ½ turn using an adjustable wrench (Figure 3:
Wireless Antenna).