Wireless Remote Base Unit for VS Series and G8610, G8611, or G8612 Series Leak Detectors
Page
8
of 14
Document No.
699910002
Revision
D
18) Rotate the antenna to its horizontal locked position.
19) Guide the antenna through its location hole in the rear cover. Then secure the rear cover to the frame using
existing hardware.
Figure 9: Label
20) Attach the label to the rear cover in location shown (Figure 9: Label).
21) Connect the power cord and power up the unit.
22)
Watch the home screen to verify the
Spectube Pressure Wait
message progresses to
Stabilization Wait
and
System Ready
within ten minutes.
Refer to the operator's manual if the system fails to reach the
System Ready
mode.
23) After installation refer to the VS Series leak detector manual (P/N # 699909942) Section 3, for leak detector
activation of the wireless remote.
24) Refer to the wireless remote user's manual (P/N # 699909945) for operational instructions.
25) Agilent recommends a full calibration of the unit prior to leak test operations.