Agilent Technologies E5100A, Programming Manual, Page: 335 / 373

WRIT16
TRAP tfOFF j ON j 0 j 1g
Set the trap function on/o. (Option 022 only)
P arameter Description OFF or 0 : Set the trap function o.
ON or 1 : Set the trap function on.
Query Response f 0j 1g
Examples OUTPUT @E5100;"TRAP ON"
OUTPUT @E5100;"TRAP?"
ENTER @E5100;A
TRAR t<value1 >,<value2 >
Set the start and the end points for the partial sweep for the trap function.
If the start point and the end point are not between 1 to the value specied by
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Number of Point , E5100A/B option 022 will perform a sweep within the possible range . Use
this function to reserve wider sweep range so that you can change the sweep range by simply
changing this setup . This way , you can save more measurement time than changing the whole
sweep setup . (Option 022 only)
P arameter Description <value1> : The start point for the partial sweep
<value2> : The end point for the partial sweep
Query Response f value1gf value2g
Examples OUTPUT @E5100;"TRAR 10, 20"
OUTPUT @E5100;"TRAR?"
ENTER @E5100;A,B
WRIT16
Set the bit width of the data outputted to the I/O port while performing the trap function to 16
bit. The port F is used. (Option 022 only)
Query Response f 0j 1g
Examples OUTPUT @E5100;"WRIT16"
OUTPUT @E5100;"WRIT16?"
ENTER @E5100;A
Option 022 G-13