Agilent Technologies E5100A, Programming Manual, Page: 289 / 373

6. Returns the maximum height of the ripple , Rpl
3
, that is the dierence
between the peak and left adjacent negative peak.
Note Y ou must select the following conditions to use this command:
Dual Channel & Coupled Channel: ON
Impedance Conversion: ON
Analysis channel: LOG MA G format
Non-analysis channel: Phase format
OUTPRESR? returns the rst two 0 phase point events found if there are more
than three corresponding points points .
If there is only one 0 phase point in the range , OUTPRESR? denes that point as
a resonant point and returns 0 for Z
a
, f
a
, Rpl
1
, Rpl
2
, and Rpl
3
.
If there is no 0 point, OUTPRESR? returns 0 for all parameters .
Examples 10 ASSIGN @E5100 TO 717
20 OUTPUT @E5100;"DUAC ON; COUC ON"
30 OUTPUT @E5100;"CHAN2; FMT PHAS"
40 OUTPUT @E5100;"CHAN1; FMT LOGM; CONV ZTRA"
50 OUTPUT @E5100;"CENT 70MHZ; SPAN 100KHZ"
60 CALL Sweep(2) ! Goes to sub routine. (See OUTPFILT?)
70 OUTPUT @E5100;"ANAOCH1;ANARFULL;ANAODATA"
80 OUTPUT @E5100;"OUTPRESR?"
90 ENTER @E5100;Zr,Fr,Za,Fa,R1,R2,R3
100 PRINT "Resonant:";Zr;"[ohm],";Fr;"[Hz]"
110 PRINT "Anti-Resonant:";Za;"[ohm],";Fa;"[Hz]"
120 PRINT "Ripple L:";R1;"[dB]"
130 PRINT "Ripple M:";R2;"[dB]"
140 PRINT "Ripple R:";R3;"[dB]"
150 END
Waveform Analysis Commands D-39