Appendix H
435
Ramp Load
Ramp Load
H. Ramp
Load
Figure H-4
Ramp Plate Thickness
Head Loading Aux Controller Setting
Follow the procedure below to set the head loading Aux controller.
The head loading Aux controller can be used both the tilt loading mechanism and the ramp
loading mechanism. There is a switch on it which changes the tilt mode or the ramp mode.
Set it to “Ramp” side as shown in Figure H-5, then LED is illuminated.
Figure H-5
Set Switch to Ramp
Plug the air fitting of
TILT AIR Down Load
and
TILT AIR Up Load
on the Aux controller as
sown in Figure H-6 using an air stopper assembly.
WARNING
The air stopper assembly and two plugs as shown in Figure H-6 are included in the
Aux controller. Usually, plug the air fitting of
TILT AIR Down Load
and
TILT AIR Up
Load
using the air stopper assembly. Because, there is a possibility that the plug blows
off from the air fitting, when high air pressure is applied to the Aux controller
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
