Agilent Technologies E364 A Series, User Manual

Page: 187 / 207

Appendix Service Information
General Calibration/Adjustment Procedure
186
13 Save the changes and select the middle current calibration point.
If the entered number is within an acceptable range, an ‘‘ ENTERED ’’ message
appears for a second. If the entered number is not correct, an error message
will be displayed for a second and you will hear a beep, and then go back to
the low, middle, or high current calibration point again as proceeding.
14 Enter the computed value (DVM reading
¸
by shunt resistance) by
using the knob and resolution selection keys.
15 Save the change and select the high current calibration point.
16 Enter the computed value (DVM reading
¸
by shunt resistance) by
using the knob and resolution selection keys
.
17 Save the new current calibration constants and exit the calibration
mode.
If the calibration fails, an error message will be displayed for one second and
you will hear a beep, and then go back to the current calibration mode again.
A ‘‘
CURRENT CAL
’’ message is displayed.
I MI 1.
5 5 5 5
000
I MI 1.5400
I HI 2.
8 8 8 8
000
I HI 2.789 A
CAL mode
Calibrate
View
Calibrate
View
Calibrate
View
Power