Part # N7210 – 90006 NT 4.0 to Microsoft Windows XP Professional with Service Pack 2 Upgrade Procedure
Page 23 of 34
Printed in USA
2. Grab handles on the front of the controller and slowly pull the system controller tray
out all of the way without completely removing it from the electronics tower.
Figure 12 Tray fully extended on the 2.8 Ghz IPC controller.
Note:
If unable to pull the system controller tray completely out, it is ok to unplug any other connections in the back of the
controller. Any unplugged connections must be plugged back in to complete the process.
3. Loosen the two (2) thumbscrews on the back of the controller, which secure the
top cover.
4. Remove the top cover of the system controller and set aside.
Install the New CD RW Drive
1. Locate the Ultra ATA 133 cable and the 4 pin power cables and disconnect both
from the existing CD RW Drive.
Figure 13 Ultra ATA 133 Cable and 4 Pin Power Cables on the 2.8 Ghz IPC Controller.
Figure 14 Detached Ultra 133 Cable and 4 Pin Power Cables on the 2.8 Ghz IPC Controller.
2. Plug the Ultra ATA 133 cable and the 4 pin power cables into the new CD RW drive.
3. Rest the new CD RW drive on the top of the open system controller.
