AGFA Drystar 5300, Reference Manual

Page: 89 / 210

89
2920B EN 20031206
Changing the interpolation
1
Perform steps 1 to 3 of the ‘Changing Image quality settings for a modality’
procedure on page 87 to select the modality and choose ‘Select other’.
The ‘Select for Modality’ screen is displayed:
2
In the ‘Select for Modality’ screen, press the Down key, followed by the
Confirm key to select ‘Interpolation’.
The ‘Interpolation’ screen is displayed:
3
Press the up/down key to select the desired interpolation setting for this
modality.
$
If you select “Cubic Hi-Res” the following screen will appear, allowing you to
adjust the smoothing factor:
Enter the smoothing factor value by means of the arrow keys. Refer to ‘Data entry’
on page 27 . Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
Select for
Modality16char:
1 Look-up table
2 Interpolation
3 MaxD
CS
Select for
Modality16char:
1 Replication
2 Bilinear
3 None
4 Cubic Hi-Res
5 CubicBell
CS
Enter smoothing
parameter:
advised value = 2.50
range [-5.00-0.00]
enter absolute value
y.yy