Afag RA-40-2F Series, Assembly And Operating Instructions Manual

Page: 46 / 56

Maintenance and repair
46 – 56 Assembly instructions EN

RA-40-2F - RA-40-4F

Date 30.10.2021

Version 2.0
9.3.1 Overview of the maintenance points
Fig. 13 Maintenance of rotational axis (exemplary RA-40-4F)
No. Maintenance point Maintenance work
Interval
System
[On/Off] Remarks
1
Rotational axis
Cleaning and
checking
As required [Off]
-

Clean the rotational axis with a dry, lint-free cloth.
- Do not spray the rotational axis with water, do not use
aggressive cleaning agents.
- Perform a visual inspection of the axis.

Check screws for tight fit.
2
Total rotational axis
check
As required [On]
- Acoustic check for unusual noise development (in case of
unusual displacement movements or hard knocks,
eliminate malfunction immediately).
3
Lubrication points
Lubricating
Every year [Off]

Chap 9.3.2

Lubrication. At all lubrication points, if necessary, press in
grease of type Klübersynth UH1 14-31 with a grease gun.
9.3.2 Lubrication
9.3.3 Further maintenance
Further maintenance is not required, if the ambient conditions listed below are
complied with:

Clean working area

No use of splash water

No abrasion or process dusts
 Environmental conditions as specified in the technical data
NOTICE
Risk of damage due to improper lubricants!
Do not use lubricants with additives such as MoS
2
, graphite or PTFE. These
lubricants can damage the module!

Only use the lubricants recommended by Afag in the maintenance table

chapter 9.3.1 or equivalent lubricants!