Afag 50113773, Assembly And Operating Instructions Manual

Page: 40 / 56

Commissioning
40 – 56 Assembly instructions EN

SA-3 I SA-3-FL I SA-6 I SA-6-FL

Edition 01/2021

Rev. 4.5
7 Commissioning
After connection, the telescope spindle axes are put into operation for the first
time via the system controller.
7.1 Safety instructions for commissioning
Observe the safety instructions in

Chapter 2 „Safety instructions“ of these
assembly instructions!
WARNING
Risk of injury during commissioning due to incorrect programming!
Incorrect programming can trigger uncontrolled movements of the telescope
spindle axis, which can lead to serious injuries as well as damage to property.

Commissioning must only be carried out in setup/jog mode.

Before working on the telescope spindle axis, make sure that the control
unit is switched off and secured against being switched on again.
CAUTION
Danger of injury in the working area of the telescope spindle axis!
Due to the decentralised control system, the operator of the telescope spindle
axis must not necessarily stand next to the module during operation so that
he may not have a complete view of the working area. Persons in the working
area may be injured.

When operating the telescope spindle axis, ensure a good overview of the
entire working area.

Unauthorized persons must not stay within the working area during
operation.
CAUTION
Risk of injuries due to uncontrolled parts movements!
Fast or unintentional movements of the telescope spindle axis may cause
injury or material damage.

Make sure that there are no persons or tools in the working area of the
module.