Afag 50113773, Assembly And Operating Instructions Manual

Page: 32 / 56

Installation, assembly & setting
32 – 56 Assembly instructions EN

SA-3 I SA-3-FL I SA-6 I SA-6-FL

Edition 01/2021

Rev. 4.5
6.3.2 Adjusting the motor position
Fig. 8 Adjusting the motor position
1. Cover
2. Fastening screws
3. Fastening screws
4. Housing
Procedure for changing the position of the motor:
1. Switch off the controller of the module.
2. Remove all cables.
3. Remove the screws M3x6 (Fig. 8, 2) and dismount the cover (Fig. 8, 1).
4. For SA-3 and SA-3-FL: Loosen the 4 x screws M4x16 (Fig. 8, 3).
5. For SA-6 and SA-6-FL: Loosen the 4 x screws M5x16 (Fig. 8, 3).
6. Rotate the housing (Fig. 8, 4) 90° to the left or right (swivel).
7. For SA-3 and SA-3-FL: Tighten 4 x screws (Fig. 8, 3) M4x16 with a
tightening torque of 4 Nm.
8. For SA-6 and SA-6-FL: Tighten 4 x screws (Fig. 8, 3) M5x16 with a
tightening torque of 6 Nm.
9. Mount and fasten the cover (Fig. 8, 1).
10. Reassemble all necessary cables.
11. Connect the controller unit.

The adjustment of the motor position is completed.
After adjusting the motor position, the telescope spindle axis must be re-
referenced (

see instructions of the controller manufacturer).
The correct toothed belt tension must be maintained and must
NOT
be
changed!
1 2
4
3