Maintenance and Repair
Assembly instructions EN
SA-3 I SA-3-FL I SA-6 I SA-6-FL
Edition 01/2021
Rev. 4.5
47–56
9.3.2 Lubrication of spindle gear
The spindle gear must be lubricated every 4 million load changes (strokes). The
module has a grease nipple on the right and left.
Fig. 15
Telescope spindle axis - grease nipple spindle gearbox
1. Dummy plug
2. Lubrication nipple
Procedure for lubricating the spindle gear:
1. Move the axis to the reference position.
2. Switch off the control and use a lockout device to make sure that the control
cannot be started up again.
3. Remove the blind plug (Fig. 15, 1) from the spindle cover.
4. Screw the grease gun attachment (see accessories) to the grease gun.
5. Lubricate the spindle with the grease gun (1 - 1.5 g).
- Recommended lubricant: Klüber Microlube GBU-Y-131
- Alternative: Type KP-1, N (DIN 51502)/Type NLGI-Class 1 (DIN 51818)
6. Refit the blind plug.
The lubrication is completed.
After lubrication, perform 2-3 strokes at low speed to distribute the lubricant
optimally.
NOTICE
Risk of property damage if unsuitable lubricants are used!
Certain lubricants with additives can cause damage to the linear unit.
Lubricants with additives (e.g.
MoS
2
, Graphite
or
PTFE
) must not be used
for maintenance of the linear unit!
2
1
Summary of Contents for 50113773
Page 54: ...54 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
Page 55: ...Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 55 56 ...
Page 56: ...56 56 Assembly instructions EN SA 3 I SA 3 FL I SA 6 I SA 6 FL Edition 01 2021 Rev 4 5 ...
