9
1) PROGRAM PARAMETER SETTINGS
Program Parameters are wrapping settings that are
effective during the entire wrapping cycle and can vary
from
program
to
program
(in
the
event
of
Multiprogramming).
WARNING: “Program Parameters” can only be
edited by Level 2 or 1 password users.
Program parameters can be used to set different
wrapping
types
(Economic/Standard),
include
supplementary devices if present such as Top,
Pressure Platen and Lifter; modify the number of High
and Low wraps, set the correct Skirting time, etc.
Furthermore, parameters set in one program can be
copied to another as described below.
“Editing program parameters”
1 – From the Main page press the “Current
Program Bar” (A) and enter the password.
After entering the password, press the “Bar"
again to open the “Program Parameters”
window.
2 – From this window select the program to be
edited by pressing key (B).
3 – Press key (C) to open the parameter
window for the program selected in point (2).
4 – Select the parameter to be edited
(wrapping, wraps, skirting time, etc.).
5 – Save settings by pressing key (D); at this
point the operator can either edit another
program or exit the “Program settings” page by
pressing key (E).
“Copying parameters from a Program”
1 – From the Main page press the “Current
Program Bar” (A) and enter the password.
After entering the password, press the “Bar"
again to open the “Program Parameters”
window.
2 – From this window select the program from
which parameters are to be copied by pressing
key (B).
3 – Press key (C) to open the parameter
window for the program selected in point (2).
4 – Proceed as in point (2) to select the
program to which parameters are to be copied.
5 – Save the parameters to be coped by
pressing key (D).
