40-7705ii-UM
Page 34
Rev. 1 June 11, 2018
Verbose:
Controls the amount of information written to limited size log
files. A pull down menu allows you to set this parameter to Off, On or Full. In
most cases, the Off setting should be used, so that only critical messages are
written to the log files. If more information about system operation is required,
the On setting can be used. The Full setting should only be used at the direction
of AES support personnel. This is an “Event” log. The more information
stored on each event reduces the total number of events stored in the log.
Set Configuration
: When complete, Click the [Set Configuration] button to
save the configuration. If you have not already created at least one Business
Unit, you will be asked to do so before leaving the Server Configuration screen.
6.2
Define Business Units: (you must have at least one)
Each subscriber unit’s application data type must be associated with a Business
Unit. Business Units are defined based on the types of application data they
process. Each Subscriber must be associated with the proper type Business Unit
to handle the data packets produced by the Subscribers. Since every Subscriber
creates at the very least, Check-In, Status and other routine messages, most
Business Units have settings for Alarm data and may have to be linked with the
Business unit of Data Type: Security, if those messages are to be monitored by
an alarm monitoring system. Each user that will have remote access would
have a Business Unit set up for their exclusive use.
To provide for site-specific particulars, there are no user Business Units pre-
configured in the MultiNet receiver from the factory. You need to create at
least one to continue.
Select “Add” under “Business Units” in the left side of the window.
Figure 6-4 Add Business Unit Screen
Some systems will only have one type of application data and one access point,
and thus will need to create only one Business Unit. If you have multiple types
of data and need multiple remote access locations, define a Business Unit for
If this is your
First Business
Unit, select this?
You can change it
later if necessary.
Do not select this
checkbox if this is
an additional
Business Unit that
will use the Serial
Port already
configured for use
by another
Business Unit.
